2 posts / 0 new
Last post
Anvil Jig setup

Hello, I'm confused what measurement to use for the bottom center head tube measurement for my Anvil Journeyman in the Jig setup tab.

There are two (X) and (Y).





Head tube bottom

The various head tube bottom measurements provided by BikeCAD Pro are described at: bikecad.ca/head_tube_bottom.  Generally, when one speaks of Head tube bottom one is referring to the vertical measurement unless the horizontal component is explicitly specified.  If it is not obvious what real world dimension the measurement scale on the fixture is showing, perhaps posting some photos could clear up the confusion.

Log in or register to post comments