Some questions about chain stay miter template generation...
1. I think there was a problem with the CS templates in pre version 8.0? I am now running version 8.0, are the CS templates working ok in this version? When I look at the miter templates for my chain stays the drive side template is different to the non-drive side? I dont understand why this is the case as both stays are identical and symmetrically attached to the bottom bracket shell?
2. What is the dimension "R" for a single curve (symetrical) chain stay? I was looking for somewhere to enter the large dimension of an oval stay and I think this might be it?
3. In my design I know the dimensions of the chain stays (16mm x 30mm) and I know the approach angle to the bottom bracket shell is 110 degrees and of course I know the diameter of the BB shell. Is there some way to generate a miter template based on these critical dimensions and not have to derive the other measurements that are asked for in the chain stay section?
Thanks in advance