BikeCAD Feature Request

Ability to bend seatstay and chainstay bridges would be cool.

Hi Brent,

I would like to be able to save the data I enter for saddle reference points (X) and (Y) with the saddle in the standard library.

When modeling saddles I use the parameter A to define where the lowest point of the upper saddle contour is. And I guess that was also your intention. But this is not necessarily the halfway point of the saddle length. When measuring the saddle height in order to get to comparable values it is often recommended to first mark that halfway point on the surface of the saddle and then measure from the center of the bb up to that point.

Hello, I'm always having trouble modeling prebent chainstays offered by many suppliers when I'm cutting up the chainstays to meet my desired cs length. I'm currently trying to use the deda cs tubes in the attached drawing.You can see that their drawings use both angle measurements (from method 2), along with radii and A/C measurements (from method 1) to the middle of the bends. If there was a 3rd method using this drawing style, I could subtract the length of my designed chainstay length from their numbers to get an offset and accurately model the chainstay bends in the right spot.

Any change you have plans to add these new HT's to the preset options?

Thx - Vince

I'd love to be able to add multiple images to a drawing. I'm finding it's very handy to import some component images (saddle and handlebars in particular) to overlay on the drawing. It's difficult if not impossible to get dimensions from manufacturers, so this goes much of the way to solving that issue.

Would it be possible to add the Tange IRD sliding dropouts? I think there are two different versions

Thanks,

Matt

It would be great to see the gen4 as an option

Thanks,

Matt

There is a 'Thru axle' option on front forks, is it possible to add this as an option on rear dropouts please?

Potentially update the brake lever options to include current models; useful for bike fitting