BikeCAD Pro How To

I could swear I once could show the clearance dimension between the rear tire and the stays, but I can't find how to toggle that dimension again!

Thanks

Alex

How do you get the standard / ghost bike to not display after I have adjusted the frame sizing?

Hi

I'm having a hard time working with BikeCAD Pro on my laptop. With 2160x1440 on a 12" screen all icons are way too tiny. How do I increase icon size by 2?

Best

Hi

I'm working with BikeCAD Pro on my laptop which is connected to an external screen half of the time. At some point I must have moved the "Display" window onto the secondary screen and today, with only the primary screen available, "Display" didn't appear.

I figured out that by changing 

<entry key="LocY DISPLAY">1662</entry>

in dialogs1.xml to

<entry key="LocY DISPLAY">162</entry>

Hi. Does anyone know if it is possible within BikeCAD to fix the frame dimensions so that when the fork length is changed the bike will pivot around its rear axle? I would like to find out how a frame whose dimensions I know with a long fork on it would be affected with by a shorter fork (i.e. what would the new head angle, bottom bracket drop, etc now be). I've tried a few different things, but every time I change the fork length the frames dimensions change to compensate. Any help would be much appreciated.

Hi Brent,

It is possible to extend BikeCad for Cantilever Bridges?

Greetings from Germany

The usual dropout dialog box is blank and there is no dropout option in Tandem dialog box. Is there a way of choosing dropouts for a tandem design in the same way as for a single bike? 

What am I missing?

Cheers

Tim

hi,

im just have unclikked all the dimension boxes manually but the sizes are still apearing on the drawing, i restarted my computers and all the all boxes are unclicked the sizes are still there, even after using the bottom left 'un-select' all option, any further ideas what to do, i run this on an apple but i belive all software is up to date .

thanks, mick

Hi folks

I wonder how i have to enter data in the tubing-size section in order to create a mitering template for tubing which is neither round nor oval, like for exeple some Columbus and Deda tubes.

Concretely i'm working on one of the Spirit top tubes which is kind of oval, but with a flat top and sides. The diameter is given as 31.7mm, dimensions are 33.5x28mm.

I am designing a bike with seat stays that attach at the head tube. The program is giving me a standover to the top of the top tube, but this is below the seat stays. Is there any way to get a measurement to the highest point on the frame, i.e., to the top of the seat stays?